Rogers Premium Roofing provides professional chimney flashing in Rogers, AR for residential and commercial properties across Northwest Arkansas. More roof leaks start at a chimney than at any other single detail, and chimney water is the most misleading water in the building. It runs down the chase, inside the framing, and surfaces in a different room, sometimes on a different floor.
That misdirection is why chimney leaks go unresolved for years even in occupied houses. In a building somebody visits a few times a year, the water can travel and stain and rot for a very long time before anyone connects the stain in the back bedroom with the masonry on the other side of the roof. By then the repair has stopped being a roofing job and turned into drywall, insulation and occasionally a rafter.
Proper flashing is a two-part system and it has been for a century. Step flashing weaves up the sides, one piece per shingle course, bonded to nothing and free to move. Counterflashing is set into a cut reglet in the mortar joint above it, folded down over the step, so that any water that gets behind the masonry is turned back out onto the roof. Nothing in it is glued to the masonry, which is why it lasts.
What we find instead, over and over, is one bent piece of flashing screwed flat against the brick face and packed with sealant. That holds while the caulk stays flexible and then quits for good, because brick and metal move at different rates and the joint opens up. More sealant is not a repair, it is a countdown.
Any chimney more than about two and a half feet wide gets a saddle built behind it, and we do not treat that as a preference. Otherwise that back wall works as a dam, holding water, ice and leaf litter along its entire width. We frame the saddle, deck it, membrane it, cover it in metal and tie it into the step flashing both sides.
The other half of the job is the chimney itself. A cracked crown, open mortar joints, a rusted or undersized chase cover on a prefabricated unit and a missing storm collar at the flue all let water in above anything a roofer flashes. We check all of it, say straight out when what you have is a masonry problem, and would rather hand you to a mason than sell flashing that cannot fix it.
Our licensed and insured team brings the right materials and equipment to every job — self-adhered membrane run up the valley and over the wall plate, hail bruising read as mat fracture under the granule layer, seal-strip bond tested by hand lift on south and west elevations, nail-shank rust used to date water intrusion from the attic side, delaminated plywood sheathing replaced sheet by sheet at tear-off, six-nail fastening in the double-thickness zone of laminated shingles — and backs the work with a written workmanship warranty. We serve Rogers and nearby communities including Bentonville, Bella Vista, Centerton, Siloam Springs.
What We Handle
Everything our chimney flashing in Rogers covers
One crew, one point of contact, and the full range of chimney flashing work in Rogers, AR. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair Rogers
- step and counter flashing
- chimney cricket saddle
- chimney chase cover
- masonry crown repair
- chimney leak diagnosis
- reglet cut counterflashing
- chimney flashing during reroof
- prefab chimney chase flashing
- chimney base leak
- chimney flashing replacement
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Rogers services.
Materials, equipment and how we do chimney flashing
The difference between chimney flashing that lasts and chimney flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with self-adhered membrane run up the valley and over the wall plate, hail bruising read as mat fracture under the granule layer, seal-strip bond tested by hand lift on south and west elevations, nail-shank rust used to date water intrusion from the attic side, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Rogers job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in Northwest Arkansas means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney flashing outside Rogers
Rogers Premium Roofing covers Rogers and the surrounding communities of Northwest Arkansas. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney Flashing in Bentonville, AR — Benton County, population 54,164
- Chimney Flashing in Bella Vista, AR — Benton County, population 30,104
- Chimney Flashing in Centerton, AR — Benton County, population 17,792
- Chimney Flashing in Siloam Springs, AR — Benton County, population 17,287
- Chimney Flashing in Lowell, AR — Benton County, population 9,839
- Chimney Flashing in Pea Ridge, AR — Benton County, population 6,559
Start on the Rogers Premium Roofing homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Rogers Chooses Rogers Premium Roofing
- ✓We ask how often somebody is actually under the roof before we quote it, because occupancy decides whether you are buying shingles or framing.
- ✓Every inspection includes the attic side. Reading sheathing from underneath is how you date water, and dating water is how you avoid paying for a roof you do not need yet.
- ✓Deck sheets and rafter-tail repair are unit-priced on the proposal. You approve the count when the tear-off is open, so the number cannot move quietly.
- ✓We keep a seasonal calendar for property that sits empty, and we call you in November and again in spring instead of waiting for the ceiling to give way.
The standards behind chimney flashing
Quality here is not a matter of opinion — it is written down. The chimney flashing work we do in Rogers follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney flashing project in Rogers gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney flashing free estimate in Rogers, or request a quote and we'll get right back to you.